P9000-02 - HIOKI High Voltage Differential Probe

P9000-02  HIGH VOLTAGE DIFFERENTIAL PROBE

Measurement functions	[P9000-01] WAVE mode only: waveform monitor output Frequency characteristics: DC to 100 kHz, -3 dB [P9000-02] (selectable) WAVE mode: waveform monitor output, AC-RMS mode: RMS value of the output AC waveform Wave mode frequency characteristics: DC to 100 kHz, -3 dB AC-RMS mode frequency characteristics: 30 Hz to 10 kHz; response time: 300 ms (rising) or 500 ms (falling)
Division ratio	1000:1 or 100:1 (selectable)
DC amplitude accuracy	±0.5% f.s. (f.s. = 1.0 V; voltage division ratio: 1000:1) (f.s. = 3.5 V; voltage division ratio: 100:1)
RMS amplitude accuracy	±1% f.s. (30 Hz to 1 kHz non-inclusive, sine wave), ±3% f.s. (1 kHz to 10 kHz, sine wave)
Input resistance, capacity	Between H and L: 10.5 MΩ, 5 pF or less (at 100 kHz)
Max. allowable input	1000 V AC/DC
Max. rated voltage to earth	1000 V AC/DC (CAT III)
Operating temperature range	-40 ˚C (-40 ˚F) to 80 ˚C (176 ˚F)
Power supply	(1) AC Adapter Z1008 (100 to 240 V AC, 50/60 Hz), 6 VA (including AC adapter) or 0.9 VA (probe only) (2) USB bus power (5 V DC, USB Micro-B receptacle), 0.8 VA (3) External power (2.7 V to 15 V DC), 1 VA
Dimensions and mass	128 mm (5.04 in)W × 36 mm (1.42 in)H × 22 mm (0.87 in)D, 170 g (6.0 oz)
Cord length	Input side: 70 cm (2.30 ft) ; output side: 1.5 m (4.92 ft)
Accessories	Instruction manual ×1, alligator clips ×2, carrying case ×1

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: